Video

How Ship Anchor Works? - Procedure For Anchoring a Ship at Sea


published on 11 July 2020 1337 -

Found on YouTube. Created by "marineinsight".
#Anchor #shipanchor #windlass
Anchoring is one of the very frequent operations onboard ships. A number of variables and external factors influence the duration and location of an anchoring operation. While the type of seabed is of utmost importance during anchoring, soft muddy grounds or clay bottoms are best preferred. It should be taken care that the anchoring bottom is free of power lines, submarine cables, pipelines or rocks.

Various methods on anchoring include consideration of direction and strength of wind, current and tidal stream. Often good local knowledge helps a mariner determine required manoeuvres and actions to be taken while anchoring.

This operations comes under the responsibility of deck officers. It involves the use of critical shipboard equipment and requires high level of situational awareness. The key responsibility of the deck officer at an anchor station is to use the anchoring machinery and available man power for carrying out the operation safely and efficiently in accordance with the master’s instructions.

In most of the cases, theoretical guidelines and bookish knowledge are helpful only to an extent. Situational awareness and spontaneity of the officers, and their instant decision making capability helps to carry out the operation fruitfully. A good knowledge of ship’s maneuverability and the limitation of the equipment involved will further help the officer to make such spontaneous decisions. The competency of the officer is decided upon his ability to consider the situation, command his crew and to assess the orders give by the Master, to carry out the operation safely and efficiently.

Read: 9 Points to Remember When Dropping Ship Anchor in Emergency - https://www.marineinsight.com/guidelines/9-points-remember-dropping-ship-anchor-emergency/

Video Credit: https://www.youtube.com/user/neo5362/
Movie Clip Credit: Caddyshack
Image Credit: http://bit.ly/2VmUB6R
What's your opinion on this?
Login or register to write comments and join the discussion!
Read more...

Video How port pilot sail out ship from the port? Grimaldi lines catania roro ship

published on 22 April 2022

In this video I will show you Grimaldi Lines Catania RoRo Ship

0

Video Pilot Leaving Ship Vigo

published on 31 March 2023

0

Opinion What is a Tug's Bollard Pull and How İt is Calculated?

by Capt.Alpertunga Anıker - published on 24 November 2022

The Bollard Pull value, which can be interpreted as the maximum thrust that is developed for a specific amount of time by the propulsion systems of any vessel to the fullest , when it has zero speed in the forward direction, is the criterion that allows us to understand how suitable a tugboat is for a port maneuver or a towing operation.

3

Video Spiral-Test -Manoeuvre for detailed identification of Yaw Stability using Samples of Cruise Ship

published on 29 September 2021

This video shows an introduction on the Spiral-Test-Manoeuvre and describes the procedure how to steer through this manoeuvre and measure the data needed. The results will be displayed in a characteristic diagram allowing to identify stable and unstable conditions and related, detailed information, e.g. spiral loop width and height, rudder angle of neutral effect. Samples of stable and unstable ship behaviour demonstrations will be shown by Fast Time Simulation using the SAMMON Planning tool.

0

Video Introduction to Pilotage

published on 6 January 2021

Pilotage is being able to navigate safely into and out of a harbour/anchorage/port knowing where you are at all times, where your hazards are and a safe route in/out. This is particularly useful if you are heading into somewhere new or a challenging/busy area – or both!

0

Video Failed overtaking of another ship in a canal - Port Revel Shiphandling

published on 10 May 2020

Manoeuvring large ships at close quarters and on shallow water is one of the most difficult aspects of shiphandling because of the complex hydraulic interactions depending on the ships' speeds, on the water depth and on lateral restrictions like in canals. Training is conducted both on meeting and on overtaking ships in shallow waters. This video shows how overtaking in a canal can easily fail.
More information: http://www.portrevel.com/3781-shiphan...

0

Article Investigation of ship maneuvering with hydrodynamic effects between ship and bank

by Marine-Pilots.com - published on 12 July 2021

When a vessel navigates in confined waters, such as in a harbour or narrow channel, it is well known among experienced pilots that the ship handling is greatly affected by the hydrodynamic forces and moments acting between ship and bank or sidewall of the channel.

1

Video Time Lapse: Pilotage of the VLCC Pisces Star, Port of Rotterdam.

published on 4 July 2019

Time Lapse Video:The deep draught VLCC PISCES STAR is approaching the Port of Rotterdam, after navigating through the Eurogeul and Maasgeul deep water channels in the Southern North Sea. The VLCC is proceeding in Calandkanaal channel to her berth in the Petroleumharbour No. 5.
Before coming alongside the VLCC is stopped and swung in the channel. Four harbour tugs are made fast to assist the manoeuvring vessel. Mooringboats bring the VLCC's steel mooring wires ashore when she is coming...

0

Article Navigation alternative in the event of GNSS failure due to jamming or spoofing

by TRENZ GmbH - published on 7 April 2025

What happens when GNSS fails? In maritime navigation, this isn’t a hypothetical scenario – it’s a growing risk. Spoofing, jamming, and GNSS outages are increasing, especially in the Baltic Sea region. A failure can cripple navigation systems – with potentially serious consequences.

1